Honda Goldwing GL1000-1100 Single Carb Manifold S&S Carburetor

Review

€359.00

Tax included

This set up is for GL1000 and GL1100 models for now.

Recommended jetting for GL1000

Main jet No 078

Intermediate jet No 0295

Security policy

We accept VISA, MASTERCARD, AM EX, Bank Wire or Revolut Payments only, due to faster service.

Delivery policy

Fast and free worldwide delivery up to 15 business days.

Return policy

We do not accept returns, but we do exchange for defective parts for free. No returns required.

Manifold and carburetor might be shipped separately, but not always. 90% of the time they might arrive on different days. Please check your note or messages for additional tracking updates. Best regards.

If you are unsure how to install the manifold and or carb after reading an Installation Guide, please take your part(s) to a licensed or certified mechanic for install. I cannot be held responsible for damaged product due to buyers lack of knowledge.
I do not accept returns due to buyers remorse, lack of understanding how to install, product damaged during installation or incorrect product purchased for your particular bike. If you have any questions, please contact.

NOTE: Engine tuning should only be performed by experienced mechanics as a "too-lean" condition can melt pistons and a "too-rich" condition can lead to excessive component wear and failure. Always do frequent plug checks or O2 measurements when making any carb adjustment.

All items are shipped via DHL Express international service, so it is guaranteed safe and on time delivery. Usually it takes from 3 to 9 business days worldwide (for manifold). Carburetor might arrive a few days later or sooner than manifold.

Honda Goldwing GL1000-1100 single carburetor manifold with S&S Super E REPLICA carburetor. CARBURETOR IS A REPLICA. Do not expect any other known brands.

Designed and engineered to convert a four carb configuration into one, avoiding four carb maintenance, especially synchronization and improves fuel efficiency. TESTED!

New design STAINLESS STEEL manifold with 99.9% optimized mixture flow. No sharp 90 degree angles inside gives an open flow straight to the cylinders. Shape of this manifold is designed the way that never leaves a leftover gas in it when engine is off witch is different, comparing to other types of GL manifolds in the market. This part is precisely engineered using a high tech "Pipe Design" software, TruLaser 5000 tube profiling machine and of course professionally TIG welded.

NOTE! This is not PLUG AND PLAY SET UP! For proper installation and tuning of this kit, a mechanical skills and knowledge about fuel supply is required. If you don't feel confident enough, I strongly recommend to get help from professional mechanic.

If you are not sure how to complete your project or have not enough confidence how to do it right, please DO NOT BUY IT!!! Don't waste yours and my time. I m not taking returns at all, only if part is defective due to manufacturing issues or so. No beginners or game players please. I m working hard to make your old timers be back on the road. Your cooperation is well appreciated. Thank you for understanding.

Materials
Stainless Steel

Parts included:
1 x Manifold

1 x Elbow

1 x Gasket

1 x Carburetor S&S Super E REPLICA (pre jetted for the first start). Usually main jet No 076, intermediate No 031

1 x Mesh air cleaner (stainless steel)

Setup used only a single throttle control cable, but decelerator cable can be used as well (your choice). Choke cable OEM is good to go.

NOTE! Installing intake elbows on the manifold use a regular hose clamps instead stock ones. Stock clamps are with the limiters and might not tie properly.

Reference

In stock 2 Items

Write your review

Honda Goldwing GL1000-1100 Single Carb Manifold S&S Carburetor

Write your review

Write your review

16 other products in the same category: